21
Getting started
Mailbox setup
When the handset is idle, press MENU/ENTER.
Press DIR or CID to scroll to Mailbox setup.
3. Press MENU/ENTER twice to select
Set access code.
4. Use the dial pad to enter a four-digit number.
Press OFF/CLEAR to backspace and delete a
digit.
5. Press the Next softkey or MENU/ENTER to save
the password and to select Mailbox security.
6. Press DIR or CID to select On or Off.
7. Press MENU/ENTER to save the setting and return
to the previous menu. There is a confirmation tone. To exit without
making changes, press OFF/CLEAR.
NOTES:
The access code must have four digits.
2. You will hear an error tone and the screen displays Please enter another if you enter
an access code that is already assigned.
Notify alert
You can receive notification calls to your cell phone or paging device
after each new phone call message has been recorded to the handset
mailbox. You can remotely access the message from a touch-tone
telephone (see page 65). To receive notification calls, you must save
your telephone number on the handset, and then set the system
to call that number after it finishes recording a message. It is best
to enter a telephone number that has caller ID service. When you
receive a notification call you will only hear silence. The silence will
last for about 15 seconds and then the call ends. If no one picks
up the call within three rings, the telephone base stops calling it.
The system only calls the alert number once. If your paging device
is busy, not available or off during the call, you will not receive thenot receive the
notification call.
1.
2.
1.
Enter mailbox
access code
:0001
Back Next
Mailbox security
:Off
Back
Set access code
Notify alert
Back
Set access code
To Next Page
Loading...
Need help?
General
Weight and Dimensions
