41
Handset operation
Push to talk (PTT) intercom
PTT call to all handsets and base
When the handset is idle,
Press and hold PTT on the side of your handset untiluntil
your handset screen shows PTT to: All.
-OR-
Press PTT. PressPress DIR or CID to choose #: All.
Press and hold PTT until your handset screen shows
PTT to: All.
When the connection is made, both the caller
and the destination parties hear two beeps. The
speakerphones on all other extensions automatically activate.
2. Speak into the speakerphone. Your voice is broadcast to all
extensions.
3. Release PTT after speaking. There is a three-second PTT wait state
with -MUTE slowly flashing on the screen. During the PTT wait
state, if necessary, you can press and hold the PTT key to continue
speaking into the speakerphone.
4. Any extension can reply (see Answer a PTT call below).
Answer a PTT call
When you hear two beeps, the screen displays PTT
from: X:Handset X (X represents the extension
number [1-0]; Handset X represents the default
handset name) or PTT from:
*
:Base.
2. Press INT to convert the call into a normal intercom
call with that extension.
-OR-
1.
1.
PTT to:
All
Release PTT key
to stop
PTT to:
All
-MUTE
PTT from:
2:Handset 2
INT
To Next Page
Loading...
Need help?
General
Weight and Dimensions
