AT&T SynJ SB67158 - Volume Control; Ringer Tone

Getting started
Telephone base setup
16
Ringer tone
Use this feature to choose one of the seven ringer tones for incoming calls.
You can choose different ringer tones for different lines so you can easily
identify which line is ringing.
When the telephone is idle, press MENU/ENTER.
Press or to scroll to Ringer setting. Press MENU/ENTER.
Press or to scroll to Ringer tone. Press MENU/ENTER.
Press REP or SKIP to select the desired line (L1, L2,
L3 or L4).
Press or to select a desired ringer tone.
Repeat steps 4-5 to choose ringer tones for other lines,
if desired.
Press MENU/ENTER to save the setting and return to the
previous menu. There is a confirmation tone. To exit
without making changes, press EXIT.
NOTE: If you turn off the ringer volume, you will not hear ringer
tone samples.
1.
2.
3.
4.
5.
6.
7.
Directory
Call log
Ringer setting
RestrictedPrefix
>
Ringer volume
Ringer tone
Ringer group
>
Ringer tone
L1 L2 L3 L4
1 3 1 1
Volume control
Use this feature to independently set the listening volume
to one of five levels for each of the three listening options
(corded handset, speakerphone and corded headset). While
using each, press , , VOL+ or VOL- to adjust the
listening volume.
While adjusting the volume on the corded handset or the
corded headset, you hear a triple beep when you reach the
minimum or maximum volume setting.
The SynJ SB67158 telephone base stores the volume setting for each
listening option.
Volume
Ringer tone
L1 L2 L3 L4
1 1 1 1