AT&T SynJ SB67158 - Call Transfer; Blind Transfer; Transfer a Call and Speak to the Receiving Party

Telephone base operation
Call transfer
56
Transfer a call and speak to the receiving party
You can transfer a call and speak to the receiving party before completing
the transfer while on a call:
Press XFER on the telephone base.
Press the one-touch EXT 1-0 key for the desired extension. for the desired extension.for the desired extension.
1.
2.
You can transfer a call to any other system telephone. Once you transfer a
call, it can be answered by any system telephone, not just at the extension
you called.
Blind transfer
While on a call, you can transfer a call directly without notifying the
desired extension:
Press XFER on the telephone base.
Press the one-touch EXT 1-0 key for the for thefor the
desired extension.
-OR-
Press or to scroll to the desired extension, thento scroll to the desired extension, then
press MENU/ENTER.
3. The current line is put on hold. The destination handset
rings and the call is answered by pressing L 1-L 4. You
hear a short tone from the telephone base. The outside
call is automatically transferred to the desired extension.
4. Put the corded handset on the telephone base or press
SPEAKER to hang up.
-OR-
You can resume the call by pressing the corresponding flashing line key
LINE 1-LINE 4 before the desired extension answers the call.
You hear a triple beep every 30 seconds when a transferred call has not been
answered (To adjust the volume of the reminder tone or turn it off, see
Hold reminder on page 22).
NOTES:
If the desired extension does not answer the intercom call within one minute, the extension rings as
an incoming call to remind the extension user.
If the outside call is put on hold for 10 minutes and Persistent hold is disabled (see page 35), it is
automatically transferred to the auto attendant. The telephone base returns to idle mode.The telephone base returns to idle mode.
1.
2.
1.
2.
Transfer to:
Handset 1
Handset 2
Handset 3
>
Calling
1:Handset 1
Hold Line1