AT&T SynJ SB67158 - Mailbox Setup (for General Mailbox); Set Access Code (Remote Code); Call Screening

Getting started
Mailbox setup (for general mailbox)
34
Use this feature to choose whether incoming messages can be heard over
the speaker as they are being recorded. If you turn call screening on, you
hear the incoming message.
If more than one incoming message comes from different telephone lines
at the same time, only the first incoming message is monitored. While the
telephone is recording the monitored message, you can answer the call by
lifting the corded handset or by pressing SPEAKER.
If you want to mute the message playback, press MUTE on the telephone base.
Follow the steps to turn the call screening on or off:
When the telephone is idle, press MENU/ENTER.
Press or to scroll to Mailbox setup. Press MENU/ENTER.
Press or to scroll to Call screening. Press MENU/ENTER.
Press or to highlight On or Off.
Press MENU/ENTER to save the setting and return to
the previous menu. There is a confirmation tone. To exit
without making changes, press EXIT.
1.
2.
3.
4.
5.
Set access code (remote code)
Use this feature to enter a four-digit number (0000-9999) to allow remote
access to your general mailbox from any touch-tone telephone. Unless you
change it, the remote access code is 0000.
When the telephone is idle, press MENU/ENTER.
Press or to scroll to Mailbox setup. Press MENU/ENTER.
Press MENU/ENTER again to select Set access code.
Use the dial pad to enter a four-digit number. Use
REMOVE to backspace and delete a digit.
Press MENU/ENTER to save the setting and return to
the previous menu. There is a confirmation tone. To exit
without making changes, press EXIT.
NOTES:
The access code must have four digits.
You will hear an error tone if you enter an access code that is already assigned.
1.
2.
3.
4.
5.
1.
2.
Directory
Call log
Ringer setting
Mailbox setup
>
Enter mailbox
access code:
0000
ENTER=Save
Enter mailbox
access code:
9999
ENTER=Save
Call screening
Call screening
:On
ENTER=Save
Set access code
Call screening
Persistent hold
Notify alert
>
Set access code
Call screening
Persistent hold
Notify alert
>