Telephone base operation
Push to talk (PTT) intercom
59
Answer a PTT call
1. When you hear two beeps, the screen displays PTT from: X:Handset X
(X represents the extension number [1-0], Handset X represents the
handset name), or PTT from: X:Deskset X (X represents the extension
number [1-0], Deskset X represents the handset name).
2. Press INT to convert the call into a normal intercom call with that
extension.
-OR-
Respond with a new PTT call. Wait for the end of the three-second PTT wait
state (the screen changes to idle mode). To respond with the telephone
base, see PTT to a single device or PTT to all devices on the previous
page. To respond with a handset, see Answer a PTT call in the SynJ
SB67108 handset manual or SynJ SB67148 deskset manual.
NOTE: If the PTT call is sent to all handsets, an intercom call is established with the first
person who presses INT.
Convert a PTT call to an intercom call
You can convert the PTT call to a two-way intercom call on the called
telephone base.
1. Press INT on the called extension to convert the call to a two-way
intercom call.
2. Optionally, put the corded handset on the telephone base or press
SPEAKER to end the intercom.
End a PTT call
Press EXIT to end the incoming PTT call. •
To Next Page
Loading...
