AT&T SynJ SB67158 - Hold Reminder; Set Date and Time

Getting started
Telephone base setup
22
When there is a call on hold for more than three minutes,
the telephone base gives you a triple beep every 30
seconds. You can set its volume to one of the three levels
or turn the hold reminder off.
When the telephone is idle, press MENU/ENTER.
Press or to scroll to Base setup. Press MENU/ENTER.
Press or to scroll to Hold reminder. Press MENU/ENTER.
Press or , VOL+ or VOL- to adjust the volume or turn
the setting off.
Press MENU/ENTER to save the setting and return to
the previous menu. There is a confirmation tone. To exit
without making changes, press EXIT.
1.
2.
3.
4.
5.
The answering system displays the date and time of the message while
playing messages. Before using the answering system, set the date and time
as follows. If you subscribe to caller ID service, the day, month and time are
set automatically with each incoming call. The year must be set so that the
day of the week can be calculated from the caller ID information.
Follow the steps to set the month, day, year and time:
When the telephone is idle, press MENU/ENTER.
Press or to scroll to Base setup. Press MENU/ENTER.
Press or to scroll to Date and time. Press MENU/ENTER.
Using the dial pad to enter the date. Press REP or SKIP
to scroll to the item you want to edit, and press the dial pad
keys to enter the correct digit.
Press to move to the time editing.
Press or to select AM or PM.
Press REP or SKIP to scroll to the item you want to edit,
and press the dial pad to enter the correct digit.
8. Press MENU/ENTER to save the setting and return to the previous menu. There is
a confirmation tone. To exit without making changes, press EXIT.
NOTES:
The time is in a 12-hour clock format. If you set an invalid time, you will hear an error tone while
pressing MENU/ENTER to save the setting. The error tone means the setting cannot be saved. You
need to correct the time entry to continue the setup process.
If the date and time are not set when a message is recorded, the system does not display date and
time on the screen while playing messages.
1.
2.
3.
4.
5.
6.
7.
1.
2.
Set date and time
Area codes
Set line mode
Hold reminder
Date and time
>
Date: 12.31. 2006
Time: 09:00 AM
^v=PM
ENTER=Save
Date: 01.01. 2009
Time: 12:00 PM
^v=AM
ENTER=Save
Hold reminder
Flashing
Line selection
Area codes
Set line mode
Hold reminder
>
Hold reminder
ENTER=Save