Chapter 6. The Firmware Upgrade Utility
39
Upgrade Succeeded
After the upgrade has completed, a screen appears to inform you that the
procedure was successful:
Click Finish to close the Firmware Upgrade Utility.
After a successful completion, the switches exit Firmware Upgrade Mode, and
reset themselves.
If you have a DCC mode installation be sure to reconnect the cable connected
to the DCC port, and set the DCC switch back to Client on the appropriate
switch (See Quad-View (DCC Mode), page 16).
CS1644A [MAIN]..
CS1644A [MAIN]
CS1644A [MAIN] 000...
CS1644A [MAIN] 000: OK
To Next Page
Loading...
