CS1642A / CS1644A User Manual
46
Front Panel
Pushbuttons not
responding
when pushed.
The daisy chain
switch located on the
back of the CS1642
A
/ CS1644
A is set to
Client.
Make sure the daisy chain switch located on
the rear of the switch is set to Host.
You should only set the daisy chain switch to
Client when connecting two units in a Quad-
View installation, see Quad-View (DCC
Mode), page 16.
The Front Panel
Pushbutton
Combo key
doesn’t work
after its set.
Some hotkeys are
not supported as
front panel
pushbutton combo
keys.
The [X] [Enter], [R] [Enter]. and [upgrade]
[Enter] hotkeys can not be set as a front
panel pushbutton combo key. Select a
different hotkey to use.
Symptom Possible Cause Action
Limited Warranty
IN NO EVENT SHALL THE DIRECT VENDOR'S LIABILITY EXCEED THE PRICE PAID
FOR THE PRODUCT FROM DIRECT, INDIRECT, SPECIAL, INCIDENTAL, OR
CONSEQUENTIAL DAMAGES RESULTING FROM THE USE OF THE PRODUCT, DISK,
OR ITS DOCUMENTATION.
The direct vendor makes no warranty or representation, expressed, implied, or statutory with
respect to the contents or use of this documentation, and especially disclaims its quality,
performance, merchantability, or fitness for any particular purpose.
The direct vendor also reserves the right to revise or update the device or
documentation without obligation to notify any individual or entity of such
revisions, or update. For further inquiries, please contact your direct vendor.
To Previous Page
Loading...
Need help?
General
