EasyManua.ls Logo

ATEQ TPMS - 3.4. Safety Precautions; 3.4.2. Battery Charging Safety; 3.4.3. Charger Safety; 3.4.4. Battery Safety Warnings

ATEQ TPMS
105 pages
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Loading...
103
3.3.7. No Other Warranties
No ATEQ dealer, agent, or employee is authorized to make any modification, extension, or addition to this
warranty.
3.3.8. Warranty Period
The warranty period for ATEQ tools is one year.
3.4. Safety precautions
You must read and understand these safety precautions and warnings before
using or charging your Li-Po batteries.
3.4.1. Operating environment
Remember to always follow any specific regulations in force in your sector of work, and to switch off your
device when its use is prohibited, or when it may cause interference or danger.
Only use the tool in its normal operating position.
3.4.2. About charging
Only use the power supply provided with your tool. The use of any other power supply may damage the tool
and/or be dangerous.
When the red LED goes off and turns green, charging is finished.
3.4.3. About the charger
Do not use this charger in wet environments; never touch the charger if your hands or feet are wet.
Allow sufficient space around the charger for ventilation when you use it to power or recharge the tool's
battery. Do not cover the charger with objects liable to affect cooling. Do not use this charger inside a bag.
Connect the charger to a suitable power outlet.
Do not use the charger if it is damaged or if its power lead is damaged. Do not disassemble the charger and
do not modify any of its parts. Do not attempt to repair the charger. It does not contain any part that can be
repaired. Replace the charger if it has been damaged or exposed to excess moisture.
Do not try to use it as a power source.
Unplug it before undertaking any cleaning or care.
3.4.4. About the battery
CAUTION: this device contains a Li-Po battery. It can explode and release
hazardous chemicals. To reduce any risk of fire or burns, do not disassemble,
crush, pierce or dispose of the battery or the tool in fire or water, and do not
short-circuit or short the contacts with a metal object.
Always use the power supply approved by ATEQ and supplied with the device.
The tool must be returned to the factory for battery replacement.

Table of Contents

Related product manuals