2.9. WiFi settings
The tool can connect to WiFi networks in order to:
• update its firmware and databases via WiFi
• send the tasks performed on the tool to the WebVT software installed on a PC
2.9.1.1. WiFi requirements and recommendation
Before wirelessly transferring the tasks performed on the tool to the WebVT software
installed on a PC, you must make sure that:
• the latest version of the WebVT software is properly installed on the PC that will
receive tasks from the tool via WiFi
• the tool is updated with the latest version of its internal firmware. To do this, use the
WebVT software and refer to the paragraph Updating on page 100
• the tool and the PC are both connected to the same WiFi network
• the WiFi router is compatible with the 802.11b standard
• the DHCP setting of the WiFi router is set to the Default Gateway setting
• MAC address filtering is disabled on the WiFi router
2.9.1.2. WiFi, sending tasks to the WebVT software
After checking the points explained in the previous paragraph, follow this procedure to
connect the tool to a WiFi network and then to transfer tasks performed on the tool to the
WebVT software.
To Next Page
Loading...
