ATEQ TPMS - 2.4.6. Copying All TPMS Sensors

53
When the programming is complete, the new sensor is created. The tool screen shows
the information related to the sensor and the message Successfully programmed.
The sensor
is created
to program
another
sensor
= back
2.4.6. Copying all TPMS sensors
This section describes copying the IDs of the 4 or 5 old sensors of a
vehicle, where these can be activated, and then copying these IDs into 4 or
5 new programmable sensors.
This option can be used to create a set of winter tires, for example.
Choose the
Copy set
mode
= next
= back