ATEQ TPMS - 3. Miscellaneous Information; 3.1. Charging the Battery

98
3. Miscellaneous
3.1. Charging the battery
A full charge enables an average of 1000 sensors to be read (approximately 160 to 200
vehicles). This data can vary based on the sensors used.
Battery level indicators
0%
25%
50%
75%
100%
When the battery reaches 0%, the battery level indicator flashes and the tool switches off
after 10 seconds.
This icon indicates that the battery is charging.
This icon indicates that the battery is faulty.
Warning! Do not use a tool with a low battery level, data issues and reception
may become unstable.
Directly connect the
charger to the tool and
then connect the charger to
a wall outlet.
Battery replacement. It is recommended to return the tool to your dealer to
replace the battery.