ATEQ TPMS - 2.10. WiFi Update

90
2.10. WiFi update
The tool can update its program and internal databases via WiFi. The procedure to
perform this operation is as follows.
If you have difficulties updating via WiFi, we recommend that you update the
internal firmware of the tool using the WebVT software installed on a PC.
Refer to Updating on page 100 to see this procedure.
First of all, make sure that the tool is connected to a WiFi network. If not, first
configure the WiFi function of the tool by following the procedure explained in
the section WiFi, connect to a network on page 83.
Use the arrow buttons to select the Update/Wifi icon.
the icon
displayed in
the top right
corner of the
screen
indicates that
the device is
connected to
WiFi.
= next
= back
Use the arrow buttons to select the Update icon.
= next
= back
Select the check mark icon using the arrows to confirm that you want to update your tool
via WiFi.