Place the tool close to the sidewall of the right front tire at the level of the right front
wheel valve and then press the Read sensor button to come out of standby and read the
sensor.
Press OK to move on to the next sensor.
Repeat the same steps for the right rear wheel, left rear wheel and spare wheel if you
have indicated that the vehicle has 5 TPMS sensors.
When a TPMS sensor cannot be brought out of standby or cannot be read, the tool
displays the message No Sensor Detected. In this case, you can:
• try to read the sensor again by pressing the read sensor button
• move to the next wheel by pressing the down arrow button
• stop the TPMS sensor reading procedure by pressing the C button
To Next Page
Loading...
