ATEQ TPMS - Page 30

30
When the IDs for all the sensors have been read and displayed on the
screen, plug the OBD-II module into the tool. The OBD-II icon appears on
the screen to confirm the connection to the module.
Then plug the OBD-II module into the OBD-II connector on the vehicle, and
turn the ignition on.
Select the
OBD icon
= next
= back
The tool will ask you to confirm before continuing.
Use the arrow buttons to select the check mark and confirm your choice by pressing the
OK button.
Select
= next
= back
Please note: leave the engine switched off while keeping the ignition switched on.
= next
= back