Manual, F/T Sensor, Ethernet Axia
Document #9610-05-Ethernet Axia-09
Pinnacle Park • 1031 Goodworth Drive • Apex, NC 27539 • Tel:+1 919.772.0115 • Fax:+1 919.772.8259 • www.ati-ia.com
84
13. Maintenance
13.1 Periodic Inspection
With industrial-type applications that frequently move the system’s cabling, check the cable jacket for
signs of wear. The Axia sensor is IP64 rated. Debris and dust should be kept from accumulating on or in the
sensor. The surface of the sensor can be cleaned with isopropyl alcohol, if contaminated by its environment.
The sensor itself should experience no wear, if used within the operating ranges and fastened to the proper
torque specication. Refer to Section15—Specications and Section 3.3—Installing the Sensor to the Robot.
13.2 Periodic Calibrating
Periodic calibration of the sensor and its electronics is required to maintain traceability to national standards.
Follow the applicable ISO-9000-type standards for calibration. ATI Industrial Automation recommends
annual accuracy checks. Refer to Section 3.6—Accuracy Check Procedure.
14. Troubleshooting
This section includes answers to some issues that might arise when setting up and using the Ethernet Axia. The
question or problem is listed followed by its probable answer or solution. They are categorized for easy reference.
The information in this section should answer many questions that might arise in the eld. Customer service is
available to users who have problems or questions addressed in the manuals.
Note
Please read the manual before calling customer service. Before calling, have the following information available:
1. Serial number (e.g., FT01234)
2. Sensor model (e.g., Axia, etc.)
3. Calibration (e.g., US-15-50, SI-65-6, etc.)
4. Accurate and complete description of the question or problem
• For the status code; refer to Section 4.8—Status Code.
5. Computer and software information. Operating system, PC type, drivers, application software, and other
relevant information about your conguration.
If possible, be near the F/T system when calling.
How to Reach Us
ATI Industrial Automation
1031 Goodworth Drive
Apex, NC 27539 USA
www.ati-ia.com
Application Engineering
Tel: +1.919.772.0115, Extension 511
Fax: +1.919.772.8259
E-mail: ft_support@ati-ia.com
To Next Page
Loading...
Need help?
General
