52
Product
presentation
Installation
Settings /
Operation
Servicing and
Warranty
Initial operation 8.
If the water heater has been tilted, wait at least 1 hour before the initial operation.
For the initial operation, the heat pump will take 5 minutes to start
I. Turn the power on to the water heater.
II. Make sure no error code is displayed on the control panel.
III. Make the settings of your water heater, see section "Setting/Operation".
IV. In the case of an electrical connection to a Peak hours / Off-peak hours signal, switch the contactor on (I)
(forced operation) to start heating immediately..
To Next Page
Loading...
