and the abbreviations of the functions of the keys below the display. Remedy the trouble if alarm LED (7)
is lit or flashes, see section Status data menu.
The display (2) will show a service message if a service plan interval has been exceeded or if a service
level for a monitored component has been exceeded. Carry out the service actions of the indicated plans or
replace the component and reset the relevant timer, see section Status data menu.
5.6 Stopping
Elektronikon regulator
Control panel of Elektronikon II
Procedure
Step Action
- Press stop button (9). Automatic operation LED (8) goes out and the compressor stops
after a programmed number of seconds of unloaded operation (programmed stop time).
- To stop the compressor in the event of an emergency, press emergency stop button
(10). Alarm LED flashes (7).
On compressors with Elektronikon II: after remedying the problem cause, unlock the
button by pulling it out and press ‘Rset’ key (5) before restarting.
Do not use emergency stop button (10) for normal stopping!
- Close air outlet valve (AV), see section Introduction.
- Press the test button on top of the electronic water drain(s) until the air system between
air receiver and outlet valve is fully depressurized. See section Condensate system.
Switch off the voltage.
- Press the test button on top of the electronic water drain(s) until the air system between
air receiver and outlet valve is fully depressurized.
Instruction book
70 API603130
To Next Page
Loading...
