NOTICE If the charging symbol and oil pressure
symbol do not extinguish, the machine must be shut
off. Fault tracing and repair must be performed by
authorized service personnel before the machine is
started again.
Starting the engine, Hatz
1. Open the rear service hatch and pick up the
transmitter. Insert and turn the battery
disconnector (A) to locked mode. The buzzer (B)
sounds when the power is switched on. The
buzzer stops when the engine starts.
2. Close the service cover and pull out the
emergency knob (C) on the machine.
3. Release the start/stop button (D) on the
transmitter. The LED will flash slowly with a green
light during normal operation.
4. Press the horn button (E) until contact is
established between the transmitter and receiver.
5. Set the switch for engine speed (F) to low.
6. Start the engine with the toggle switch (G),
release when the engine has started.
7. Check the battery status. The low-battery warning
light (H) must not light. Always have an extra
fully-charged battery available.
8. Check the oil pressure.
The flashing warning light (A) mounted on the hood
is activated when the battery disconnector and
emergency stop are activated.
System information
When the transmitter is turned on, the following data
will be shown on the display:
A. Engine running hours.
B. Software version for the machine's ECU
(Electronic Control Unit).
C. Software version for the radio receiver.
D. Software version for the radio transmitter.
© 2015 Construction Tools EOOD | No. 9800 1147 01d | 2015-11-11
Original instructions
20
LP 8504Safety and operating instructions
To Next Page
Loading...
