♦
Check that the level is in the centre of the gauge.
Refill if necessary.
♦
Check for leaks if the level falls.
Scrapers, checking and adjusting
♦
Make sure that the scraper blades are not touching
the pads on the drums. If necessary, adjust the
screws (A) to a clearance of 3-5 mm (0.12- 0.2
in.).
Checking bolted joint
Check and if necessary tighten screws and nuts.
NOTICE Never aim a water jet directly at the fuel
filler cap. This is particularly important when using a
high-pressure cleaner.
Cleaning the machine
♦
Do not spray water directly onto electrical
components or the instrument panel.
♦
Place a plastic bag over the fuel filler cap and
secure with a rubber band. (This will prevent water
from entering the venting hole in the filler cap.
Otherwise this could cause operational
disturbances, such as clogged filters.)
After the first 20 hours of
operation
Maintenance routines:
♦
Check the engine spacer bolts.
♦
Change the engine oil and replace the oil filter.
See the engine manual for more information.
♦
Check and adjust engine valve clearances. See
the engine manual for more information.
Inspection of engine spacer bolts
Check that the engine spacer bolts (A) are properly
tightened.
Diesel engine, changing the oil and filter
Only drain the engine oil while engine is warm.
© 2015 Construction Tools EOOD | No. 9800 1147 01d | 2015-11-11
Original instructions
26
LP 8504Safety and operating instructions
To Next Page
Loading...
