1. Unscrew the drain plug (A) on the draining hose
and drain off all the oil. Use a container with at
least a 2.5 litre capacity.
2. Replace the drain plug (A) and tighten.
3. Loosen the oil filter (B) by using a band wrench.
4. Clean the surfaces (C) carefully.
5. Replace the oil filter (D) and tighten by hand.
6. Fill with engine oil.
7. Run a for a short time to make sure that the oil
filter is oil tight. If necessary tighten.
After the first 150 hours of
operation
Maintenance routines:
♦
Change the hydraulic oil filter.
Hydraulic system, replacing the oil filter
1. Clean the area around the filter cover and then
unscrew the cover (A). Replace the filter element.
The element is a disposable type and must be
disposed of in an environmentally-friendly
manner.
2. Insert the new filter in the housing and check the
O-ring in the cover.
3. Screw the cover back on and make sure there
is no leakage.
Every 250 hours of operation
(every month)
Maintenance routines:
♦
Change the hydraulic oil filter.
♦
Change the fuel filter.
♦
Change the air filter.
♦
Check shock absorbers.
♦
Drain the fuel filter.
♦
Check the battery connections.
♦
Check the engine spacer bolts.
♦
Check and clean the engine air cooling system.
See the engine manual for more information.
♦
Change the engine oil and replace the oil filter.
See the engine manual for more information.
♦
Check and adjust engine valve clearances. See
the engine manual for more information.
27© 2015 Construction Tools EOOD | No. 9800 1147 01d | 2015-11-11
Original instructions
Safety and operating instructionsLP 8504
To Next Page
Loading...
