DescriptionSymbol
Radio contact established between
transmitter and receiver.
Alarm, charging.
Alarm, low oil pressure.
Fault codes:
05: Tilt switch activated.
The front switch is located behind the
engine on the right side of the machine. The
rear switch is located on the left side of the
machine.
06: Rear contact sensor activated.
07: Front contact sensor activated.
Radio contact lost between transmitter and
receiver.
Transmitter connected via cable control.
Stopping the engine, Hatz
1. Set the vibration switch (A) to neutral position.
2. Set the speed switch (B) to low (tortoise).
3. Set the engine speed switch (C) to low.
4. Let the engine idle for a few minutes.
5. Push the start/stop switch (D) back. The buzzer
(E) sounds when the engine stops.
6. Open the rear service cover and twist the battery
disconnector (F) back to stop the buzzer.
7. Turn off the transmitter with the start/stop button
(G), the green LED indicator light turns off.
8. Place the transmitter in its transportation position
in the machine or store it in a safe place.
NOTICE The machine will stop immediately when
the emergency stop knob is pressed. Make sure that
the emergency stop is always in working order.
NOTICE The machine stops immediately when the
joystick is released. Make sure that the joystick is
working and that it returns to zero mode when it is
released.
NOTICE The machine stops immediately when the
on/off switch on the transmitter is turned off.
Handbrake
♦
Release the handbrake (A) by pulling it out and
twist it clockwise into locked position.
♦
Engage the handbrake by twisting it
counterclockwise and push it in.
Cable control
NOTICE The connector must be cleaned before
mounting the cable. Damaged connectors must be
replaced by authorized personnel.
21© 2015 Construction Tools EOOD | No. 9800 1147 01d | 2015-11-11
Original instructions
Safety and operating instructionsLP 8504
To Next Page
Loading...
