The machine can be operated by cable control.
♦
Mount the cable on the machine.
♦
Mount the cable on the transmitter.
♦
The machine is ready to use. Use the same
procedure for start/stop and operating as when
using radio control.
♦
When cable control is used, the transmitter battery
is not needed. The transmitter receives power via
the cable.
♦
Store the cable in the pocket under the centre
hatch, when it is not in use.
Operating
NOTICE The vibration position must not be used
when the engine is idling.
Operation
The machine must always be operated at the highest
engine revs when vibration is used, the engine revs
switch (A) is then in position +. Speed switch (B)
must be in the position for low speed.
Operating with automatic vibration
Set the vibration toggle switch (C) in position AUTO.
Vibration is activated when the joystick is used and
the machine is operated at low speed. For the best
tractive force, the vibration direction is changed
automatically when the machine is operated forwards
or backwards.
Operating with manual vibration
Set the vibration toggle switch (C) in position MAN.
The starting position for engine speed switch (D) is
neutral position.
When the engine speed (D) is set to low, the
automatic vibration is stopped. Vibration toggle switch
(C) must be set to the intermediate position when
returning to high speed in order for the automatic
vibration to be resumed.
Vibration switch position
Vibration is clockwise.
Vibration is anticlockwise.
© 2015 Construction Tools EOOD | No. 9800 1147 01d | 2015-11-11
Original instructions
22
LP 8504Safety and operating instructions
To Next Page
Loading...
