- 51 -
Following condition is taken into account, before the
COOLDOWN SEQUENCE can be ended:
COOLDOWN TIMER ≥
COOLDOWN TIME°
During the COOLDOWN SEQUENCE, if the
COOLDOWN ‘MODE’ is set to ‘timer and
temperature based’ the following view is shown:
During the COOLDOWN SEQUENCE, if the
COOLDOWN ‘MODE’ is set to ‘timer based’, or if
the temperature condition has been met, the following
view is shown:
After cooling down, the engine enters the STOP
SEQUENCE. During the STOP SEQUENCE, before
the ENGINE RPM is being re-read, the following
view is shown:
MAIN VIEW
ENGINE COOLING DOWN
3.3 bar1200RPM1286h
180s
1s
0s
480°C
401°C
400°C
40%
MAIN VIEW
ENGINE COOLING DOWN
6.0 bar1200RPM1286h
180s
74s
0s
40%
Active Buttons:
Start Button
(to initiate Start command)
Measurement View Button
Settings View Button
Alarms View Button
MAIN VIEW
ENGINE STOPPING
5.3 bar508RPM1286h
40%
To Next Page
Loading...
