- 27 -
3.4 Electrical features
The electrical features described in this chapter are
standard provided on this compressor.
3.4.1 Pc4003™ controller
The Pc4003™ module is built in into the side of the
rear right corner panel, with an emergency stop button
nearby at the rear side of the unit, for maximum safety
during the cranking procedure. It communicates with
a display unit, located in front of the control panel.
The control module will carry out all necessary tasks
to control and protect the compressor, regardless of
the use of the compressor
This means that the Pc4003™ module can be used for
several applications.
3.4.2 Battery switch
The compressor is equipped with a battery switch.
When the compressor is not in use this switch must
always be in the “OFF” position.
It is not allowed to use this switch as an emergency
switch or for stopping the compressor.
3.4.3 Battery charger
To maintain the battery voltage the compressor is
equipped with an automatic battery charger:
– Battery charger EEC/AUS: 240 VAC / 24 VDC -
100 VA
– Battery charger USA: 120 VAC / 24 VDC -
100 VA
For more detailed info on the battery charger, see also
section “Maintaining the battery voltage”.
3.4.4 Sockets EU
The PTS 800 T3 Cud EU variant is equipped with the
following sockets:
Do not switch off the battery switch
immediately after stopping and
cooldown! See battery switch label.
X6 Socket battery charger 230 V and
Socket heater (optional)
X14 Socket remote emergency stop
X17 Power outlet socket 24V
To Next Page
Loading...
