- 26 -
• The unit will start automatically at a start
command (e.g. a remote start signal or set
timer).
In cold conditions the unit might not start from
the first attempt. The controller will take 3
start attempts.
4.2.2 During operation
Regularly carry out following checks:
– Check the controller display for normal readings.
– Check for leakage of oil, fuel or coolant.
– Check that the voltage between the phases is
identical and that the rated current is not
exceeded.
– When single-phase loads are connected to the
generator output terminals, keep all loads well-
balanced.
– If circuit breakers have tripped during operation,
switch off the load and stop the generator. Check
and, if necessary, decrease the load.
4.2.3 Stopping
– When in MANUAL mode:
• Switch off the load.
• Switch off circuit breaker Q1.
•Press the STOP button to stop the generator
immediately after cooldown.
– When in AUTO mode:
• Switch off the load.
• The engine will stop when a stop command
(e.g. a remote start/stop signal or set timer) is
given.
– Turn starter switch S20 in position O (OFF) to
shut down the voltage supply towards the
Qc1103™ controller.
– Lock all doors to avoid unauthorized access.
Avoid to let the engine run out of
fuel. If it happened, priming will
speed up the starting.
Avoid long low-load periods
(< 30%). In this case, an output
drop and higher oil consumption of
the engine could occur. Refer to
‘Preventing low loads’.
The generator’s doors may only
remain opened for short periods
during operation, to carry out
checks for example.
To Next Page
Loading...
Need help?
General
