58
April 2007
e-motion™ Operating Manual - B-Level STD
PERIPHERALS VOLTAGE REQUIREMENTS & CONNECTORS PIN-OUT
Playfield Up / Down Button
Required Voltage: 12V
Connected to: Buttonboard
Connector: P7
Bill & Coin Decal
Required Voltage: 12V
Connected to: Buttonboard
Connector: P6
Button Panel
Required Voltage: 12V
Connected to: Buttonboard
Connector: P8
Doormotor
Required Voltage: 24V
Power Consumption: max. 2,5A
Connected to: Hopperboard
Connector: P3
Main Display (TFT 1)
Required Voltage: 12V N/A
Connected to: Graphiccard
Connector: S12
Upper Display (TFT 2)
Required Voltage: 12V N/A
Connected to: Graphiccard
Connector: S15
Doormotor - forward:
pin 1 = +24V
pin 2 = GND
Doormotor - reverse:
pin 1 = GND
pin 2 = +24V
VOLTAGE / PIN-OUTS
To Next Page
Loading...
