User’s Manual
14
The box beside Version displays the software version of the DVR. To upgrade the software, connect a USB device
containing the upgrade package file to the DVR. If you enabled the NetFS function (Network menu > NetFS tab),
you can download the file from the registered NetFS site. Highlight Upgrade… and press the
button. Select USB
Storage or NetFS. If you select NetFS, select a NetFS site from the registered NetFS site list. The Upgrade screen
appears. The screen displays the upgrade package file names that are available. The “.rui” indicates that the file is for
software upgrades.
Select the desired file and press the button. Highlighting the Install button and pressing the button will install
the selected software package. Highlighting the Cancel button and pressing the
button will close the window without
upgrading the software. If the upgrade package file is not installed on the DVR properly, you will get an error message.
The system restarts automatically after completing the upgrade.
CAUTION: The USB device must be FAT16 or FAT32 format.
You can import saved DVR settings or export the current DVR settings. To import saved DVR settings, connect the
USB device containing the setup file (.dat) to the DVR. If you enabled the NetFS function (Network menu > NetFS
tab), you can download the setup file from the registered NetFS site. Highlight Setup – Import… and press the
button. Select USB Storage or NetFS. If you select NetFS, select a NetFS site from the registered NetFS site list.
Select the desired setup file and press the Import button to import the selected settings and change the DVR settings
accordingly. Highlight Include Network Setup and press the
button to toggle between On and Off. When set to Off,
the network settings will not be changed.
To export the current DVR settings, connect the USB device to the DVR. If you enabled the NetFS function
(Network menu > NetFS tab), you can upload the setup file on the registered NetFS site. Highlight Setup –
Export… and press the
button. Select USB Storage or NetFS. If you select NetFS, select a NetFS site from the
registered NetFS site list. Highlight the box beside File name and press the
button. A virtual keyboard allows you
to enter the file name. Selecting Export will save the current settings in .dat file format on the USB device or the
NetFS site.
NOTE: Even after changing the DVR settings by importing saved settings, the time-related settings (Date/Time,
Time Zone and Daylight Saving Time) will NOT be changed.
CAUTION: The USB device must be FAT16 or FAT32 format.
To Next Page
Loading...