AuCom EMXAe - Remote Keypad; Lighten;Darken the Display

KEYPAD AND FEEDBACK
7.2 Remote Keypad
The remote keypad can be used to control the soft starter if parameter 1A
Command Source is set to 'Remote Keypad'.
• If the remote keypad is not selected as the command source, the
START
,
STOP
and
RESET
buttons will have no effect.
• The menu navigation buttons and display on the remote keypad are
always active.
• If a button is pressed on the starter's local keypad, the display on the
remote keypad will update to match.
NOTE
The remote keypad can be safely connected or removed while the starter is
running. It is not necessary to remove mains or control voltage.
NOTE
If parameter 1A
Command Source is set to Remote Keypad, removing the
remote keypad will cause a trip.
7.3 Lighten/Darken the Display
The backlight on the display can be adjusted:
• to lighten the display, hold down the
button and press the key
• to darken the display, hold down the
button and press the key
NOTE
The local and remote keypads can be adjusted independently.
42 | EMX4e User Manual (710-18433-00C)