AuCom EMXAe - Parameter List

PROGRAMMABLE PARAMETERS
9.4 Parameter List
Parameter Group
Default Setting
1
Motor Details
1A Command Source Digital Input
1B Motor Full Load Current Model dependent
1C Locked Rotor Time 00:10 (mm:ss)
1D Locked Rotor Current 600%
1E Motor Service Factor 105%
1F Reserved
2
Motor Start/Stop
2A Start Mode Constant Current
2B Start Ramp Time 00:10 (mm:ss)
2C Initial Current 200%
2D Current Limit 350%
2E Adaptive Start Profile Constant Acceleration
2F Stop Mode TVR Soft Stop
2G Stop Time 00:00 (mm:ss)
2H Adaptive Stop Profile Constant Deceleration
2I Adaptive Control Gain 75%
2J Multi Pump Single Pump
2K Start Delay 00:00 (mm:ss)
5
Protection Levels
5A Current Imbalance 30%
5B Current Imbalance Delay 00:03 (mm:ss)
5C Undercurrent 20%
5D Undercurrent Delay 00:05 (mm:ss)
5E Overcurrent 400%
5F Overcurrent Delay 00:00 (mm:ss)
5G Excess Start Time 00:20 (mm:ss)
5H Restart Delay 00:10 (mm:ss)
5I Starts per Hour 0
5J Phase Sequence Any Sequence
6
Protection Actions
6A Auto-Reset Count 0
6B Auto-Reset Delay 00:05 (mm:ss)
6C Current Imbalance Soft Trip and Log
EMX4e User Manual (710-18433-00C) | 53