Need help?Do you have a question about the AuCom EMX3-1600C and is the answer not in the manual?
Details hazards related to electrical shock from the starter.
Warns about accidental starts and unexpected operation.
Outlines the steps for initial configuration and setup of the soft starter.
Provides guidelines for mounting and physical installation of the soft starter.
Details the wiring connections for control terminals on the soft starter.
Explains how to wire the fixed inputs for remote control.
Explains how to connect the motor in-line or inside delta configurations.
Lists UL short circuit ratings and fuse selection guidance.
Describes the keypad layout, buttons, and status LEDs.
Describes how to control the soft starter using keypad or remote inputs.
Overview of different soft start methods like Constant Current and Adaptive Control.
Describes various stop methods like Coast To Stop, TVR Soft Stop, and Adaptive Control.
Explains the DC brake function, its stages, and configuration.
Shows wiring for installing EMX3 with a main contactor.
Explains how the starter responds to protection conditions.
Lists trip messages, causes, and solutions.
Describes situations where the starter doesn't operate as expected.
General| Model | EMX3-1600C |
|---|---|
| Type | Soft Starter |
| Rated Operational Current Ie (A) | 1600 A |
| Current Rating | 1600 A |
| Frequency | 50/60 Hz |
| Control Voltage | 100-240 VAC |
| Ambient Temperature | -10 to +50 °C |
| Protection | Overload |
| Communication | Modbus |
To Next Page
