Audi A3 1997 - 1.14 - Removing, installing and adjusting Bowden cables from;on the heater control

Protected by copyright. Copying for private or commercial purposes, in part or in whole, is not
permitted unless authorised by AUDI AG. AUDI AG does not guarantee or accept any liability
with respect to the correctness of information in this document. Copyright by AUDI AG.
- Change adaption value by means of direct entry => "B - Changing adaption value by means of direct entry",
Page 75 .
- Enter 5-digit adaption value. Use "0" to fill up empty spaces.
Example:
Desired input: 4352 for CAN radio
Keypad entry: 04352
-> Display on VAS 5051 following adaption:
Example:
1 - Channel 61
Value 4352 saved
- Terminate function "10 - Adaption" by touching ◂ key.
Adaption channel 62 - control units using information data bus (Highline dash panel insert only)
Note:
This adaption channel is only used for vehicles with Highline dash panel insert (with driver information system).
This function can be used to enter control units using information data bus on dash panel insert replacement.
-> Display on VAS 5051:
1 - Enter channel number
- Use keypad -2- to enter "62" for "Adaption channel 62" and confirm by touching Q key.
Audi A3 1997 ➤
Electrical system Self-diagnosis - Edition 02.2002
3.11 - Adaption 105