(D Tips
- Multiple versions of charging cables are of-
fered due to the different power supply sys-
tems in different countries. The maximum
charging power may potentially be unavaila-
ble because of this . Contact an author ized
Audi dealer or authorized Audi Service Fa-
cility for more informat ion .
- Charging may take longer when tempera-
tures are extremely high or low.
- The charging t ime at public charging sta-
t ions may vary from the times given in the
tab le
o table on page 114 .
Audi e-tron charging system PIN
Applies to: vehicles with plug-in hybrid drive
The contro l unit can be locked by enter ing a 4-
digit PIN of your choice. If a PIN is act ivated, the
se lected PIN must be entered before every use.
We recommend locking your contro l unit to pro-
tect it against unautho rized access by a third par-
ty.
Activating the PIN
.,. Press the I OKI@ o page 109, fig . 11 S button
on the control un it .
POWER and SET PIN ap-
pear in the display field .
.,. Select
SET PIN using the arrow button @ .
.,. Press t he IOKI button @ .
ENTER PIN appea rs in
the disp lay field .
.. Select the desired value by pressing the arrow
buttons © up or down .
.. Use the right arrow button © to go to the next
digit .
.. Press the left arrow button © to go to the pre-
vious menu .
.,. Enter all of the digits .
.,. Press t he IOKI button @ afte r the last digit.
.,. REPEAT PIN appears in the display field .
.,. Ente r t he PIN aga in using the arrow but t ons
©-
.. Press th e IOKI button @ .
.. PIN OK appears in the display field if both en-
::li tries match.
...
~
.. The PIN is now activated.
N
...
0
N
>
00
e-tron
Deactivating the PIN
Requirement: t he cont rol unit must be unloc ked.
.,. Enter the numerical code
0000 . Proceed as if
you were activating the PIN
o page 115.
.. The PIN is deactivated.
Locking the control unit
Requirement: the PIN must be activated .
.,. Press the
Iii button @ o page 109, fig. 11 Son
the contro l unit .
Unlocking th e control unit
Requirement: the PIN must be act ivated .
.,. Press any button on the control unit .
.,. PIN? appears in the display field.
.,. Enter the PIN .
.. Press the
I OK! button @ .
(j) Tips
- The PIN is deactivated in t he factory defa ult
sett ings.
- If you do not remembe r your PIN, contact
an aut horized Audi dealer or autho rized
Audi Service Facility .
- If the first PIN entry differs from the second
ent ry, t he first PIN entry is displayed .
- If nothi ng is entered within 20 seconds of
this, the set val ue is not changed .
Indicator Lights and
messages
Applies to: vehicles with plug-in hybrid drive
If the B indicator light turns on, the high-volt-
age battery is charging or is already comp letely
charged .
If the . indicator light stays on, there is a ma l-
function in the charging system . Have the prob-
lem corrected immediately by an authorized Audi
dealer or authorized Audi Service Facility.
l!i1 Charging conn ecto r still attached . Vehicle
cannot be driven
This message appears when t he cha rging system
is st ill connec ted to the vehicle. Remove the con-
nector
o page 112, A~er charging . ..,.
115
To Next Page
Loading...
