A ss is tanc e s y s tem s
A WARNING
You should only resume the stored speed if it
is not too high for existing traffic condit ions.
Otherwise you can increase the risk of an acci-
dent .
Lap timer
Introduction
Applies to: vehicles with lap timer
You can measure and analyze lap times with the
lap timer in the display.
Opening th e lap timer
i.. Open the first Vehicle tab (t rip computer) using
t he
l<l 1>1 button on t he mult ifunct ion steer ing
whee l.
i.. Applies to: vehicles with analog instrument
cluster: Press the
[gJ button on the m ultifunc -
tion steering whee l and select
Lap t imer in the
menu .
... Applies to: vehicles with Audi virtual cockpit: on
the multifunction steering wheel, select: left
contro l button
> Lap times .
Operat ing the lap t imer
... On the multifunction steering whee l, turn the
left thumbwhee l
(J) ¢ page 13 or (D ¢ page 16
unt il the desired menu item is d isplayed in the
instrument cluster .
... Press the left thumbwheel to confirm the selec -
tion .
A WARNING
Your foc us should always be on d riving your
vehicle safely. As t he drive r, you have com-
ple t e responsibi lity for safety in traffic. Only
use the functions such as the lap timer in such
a way that you always maintain comp lete con-
trol over your vehicle in all traffic situations.
(D Tips
You can ret rieve information from the t rip
computer while the lap t imer stopwatch is
running .
122
-
Lap times and timing
Applies to: vehicles with lap timer
Requirement: the lap time r must be open
¢ page 122.
Timing laps
... To start timing, select Lap 1 - press OK or Start
lap 1 in the menu .
i.. Applies to: vehicles with Audi virtual cockpit: to
start t iming au t omatically when yo u start dr iv-
ing, select
St art lap 1 by driving off or St art by
driving off in the menu .
... To measure the lap time, select
New lap - press
OK or New lap
in t he menu . This starts timing
the next lap at the same t ime .
After completing, the d ifference between the
last lap and the previous best lap time will be in-
dicated with a" - "/ . or
"+"fll .
Pausing timing and displaying a split time
i.. To insert a pause m, sele ct Pause in the menu.
i.. To cont inu e tim ing, select Press OK to resume
or Resume in the menu .
... To display a sp lit time, select
Split time in the
menu. The split time
r~1 appears for approxi -
mate ly 10 seconds in the instrument cluster .
The timing of the current lap continues.
Resetting timing
... Using the mult ifunct ion steer ing whee l, select
Reset or Reset time s in the menu.
(D Tips
- A max imum of 30 lap t imes (analog instru-
ment cluster) or 99 lap times (Audi virtua l
cockpit*) can be measured.
- If tim ing is paused, you can continue it later
even if you switch the ignition off.
- Saved lap times cannot be individually de-
leted from the total results .
- The save d la p t imer values w ill remain after
switching t he ignition off.
To Next Page
Loading...
