Audi TT - Page 140

Protected by copyright. Copying for private or commercial purposes, in part or in whole, is not
permitted unless authorised by AUDI AG. AUDI AG does not guarantee or accept any liability
with respect to the correctness of information in this document. Copyright by AUDI AG.
– Install the bracket -A-, make sure the guides on the bracket
-B- are inserted correctly into the intake housing mount -C- and
that the bracket is engaged correctly in both catches -D- and
-E-.
– Check both motors, it must be held in its position by bracket
-A-, if it is not installed free of play, use some foam to rectify
play if necessary, attaching it to inside of mounting points -F-
of bracket -A-.
Reinstall all removed components in the opposite sequence while
observing the following:
– Install the wiring harness so that it cannot come in contact with
any moving parts (e.g. the actuating arm of the control motor).
– Check Climatronic control module -J255- DTC memory and
erase any possible displayed malfunctions using Vehicle di‐
agnosis, testing and information system -VAS5051B- in the
"Guided Fault Finding" function.
– Perform a basic setting and output diagnostic test on the A/C
(heater) and check the DTC memory one more time. Refer to
Vehicle diagnosis, testing and information system -
VAS5051B- in the "Guided Fault Finding" function.
Note
In the event of problems with moisture in passenger compart‐
ment, additionally check recirculated-air door (must close com‐
pletely).
Audi TT 2007 ➤
Heating, Ventilation and Air Conditioning - Edition 01.2011
136 Rep. Gr.87 - Air Conditioning