Protected by copyright. Copying for private or commercial purposes, in part or in whole, is not
permitted unless authorised by AUDI AG. AUDI AG does not guarantee or accept any liability
with respect to the correctness of information in this document. Copyright by AUDI AG.
– Remove the rubber seal -1- and remove plenum chamber
cover -2- by carefully pulling it off retainers on windshield. Re‐
fer to⇒ Body Exterior; Rep. Gr. 50 ; Removal and Installation .
Checking
– Ensure fresh air intake cover -B- is installed correctly and is
not damaged.
– Remove bolts -A- (tightening torque 2.5 Nm).
– Remove cover -B-.
Installation
Installation is done is reverse order, observe the following:
Note
♦
Before installing, check bonded seal and cover -B-, replace a
damaged seal or cover.
♦
When installing, ensure cover -B- and accompanying seal are
seated correctly. If cover is not installed correctly, water can
run into the A/C unit air intake shroud.
♦
If the fresh air intake cover is damaged, it must be replaced.
5.13 Front Upper Body Outlet Temperature
Sensors -G385 - / -G386-
Left Front Upper Body Outlet Temperature Sensor -G385 - / Right
Front Upper Body Outlet Temperature Sensor -G386-
Note
♦
This temperature sensor is always installed on the driver's
side. The Left Front Upper Body Outlet Temperature Sensor
-G385- is installed in the air guide channel leading to the left
instrument panel vent.
♦
On vehicles with heating (without A/C system), no upper body
outlet temperature sensor is installed (depending on version,
mounting opening in air guide channel is not present or is
sealed with a sealing plug).
Removing
– Switch off ignition.
– Remove the driver side storage compartment. Refer to⇒ Body
Interior; Rep. Gr. 70 ; Removal and Installation .
Audi TT 2007 ➤
Heating, Ventilation and Air Conditioning - Edition 01.2011
5. Removal and Installation 143
To Next Page
Loading...
