Protected by copyright. Copying for private or commercial purposes, in part or in whole, is not
permitted unless authorised by AUDI AG. AUDI AG does not guarantee or accept any liability
with respect to the correctness of information in this document. Copyright by AUDI AG.
Before installing the A/C compressor, refer to ⇒ Refrigerant
R134a Servicing; Rep. Gr. 00 ; Removal and Installation .
Note
♦
Coat the O-ring seals lightly with refrigerant oil prior to instal‐
lation. Refer to ⇒ “1.21 Refrigerant Circuit O-rings“, page 41 .
♦
An uncertain quantity of refrigerant oil remains in a removed
A/C compressor. Therefore, observe the notes for replacing
the A/C compressor. Refer to⇒ Refrigerant R134a Servicing;
Rep. Gr. 00 ; Removal and Installation .
♦ Tightening torque; vehicles with a 4 or 6 cylinder engine. Refer
to
⇒ “5.1 A/C Compressor, Removing From Bracket“,
page 103 . Vehicles with 5 cylinder engine, refer to
⇒ “5.2 A/C Compressor, Removing From Bracket“,
page 106 . Attach the refrigerant lines to the A/C compressor.
Refer to
⇒ “5.18.1 A/C Compressor Refrigerant Lines“, page 154 .
♦ Replace the O-ring seals on opened connection points, ver‐
sion, refer to Electronic Parts Catalog.
– Remove the A/C compressor from the bracket. Refer to
⇒ “5.1 A/C Compressor, Removing From Bracket“, page 103
or
⇒ “5.2 A/C Compressor, Removing From Bracket“,
page 106 .
– After installing a new A/C compressor (or after charging com‐
pressor with cold refrigerant oil, such as, after flushing refrig‐
erant circuit) run the A/C compressor through 10 rotations by
hand after installing and before routing the ribbed belt.
Note
The A/C compressor on 5 cylinder vehicles have 2 ribbed belts.
The A/C compressor has a belt pulley with a double belt guide.
Refer to
⇒ “5.2 A/C Compressor, Removing From Bracket“, page 106 .
– Mount the ribbed belt(s) on the ribbed belt pulley. Refer to ⇒
Engine Mechanical; Rep. Gr. 13 ; Removal and Installation .
– Discharge and fill the refrigerant circuit. Refer to⇒ Refrigerant
R134a Servicing; Rep. Gr. 00 ; Description and Operation (A/
C Service Station).
– Install remaining components.
– Operate the A/C system after filling the refrigerant circuit. Re‐
fer to
⇒ “1.4 A/C System, Operating After Filling Refrigerant Circuit“,
page 28 .
Audi TT 2007 ➤
Heating, Ventilation and Air Conditioning - Edition 01.2011
158 Rep. Gr.87 - Air Conditioning