Protected by copyright. Copying for private or commercial purposes, in part or in whole, is not
permitted unless authorised by AUDI AG. AUDI AG does not guarantee or accept any liability
with respect to the correctness of information in this document. Copyright by AUDI AG.
– Install the filter (with the strainer) -2- with the correct side into
the condenser reservoir.
– Remove the dryer cartridge from its original package.
– Insert the dryer cartridge into the condenser reservoir.
– Install the cap -A-.
– Install the Seeger ring -arrow-.
– Install the cap -1-.
– Install the condenser. Refer to 4 cylinder
⇒ “5.18.3 Condenser“, page 159 or 6 cylinder
⇒ “5.18.5 Condenser“, page 164 .
– Install remaining components.
– Discharge and fill the refrigerant circuit. Refer to ⇒ Refrigerant
R134a Servicing; Rep. Gr. 00 ; Description and Operation (A/
C Service Station).
– Operate the A/C system after filling the refrigerant circuit. Re‐
fer to
⇒ “1.4 A/C System, Operating After Filling Refrigerant Circuit“,
page 28 .
Note
Note the information regarding operating the A/C system after
filling. Refer to ⇒ Refrigerant R134a Servicing; Rep. Gr. 00 ;
Description and Operation (A/C Service Station).
Audi TT 2007 ➤
Heating, Ventilation and Air Conditioning - Edition 01.2011
170 Rep. Gr.87 - Air Conditioning
To Next Page
Loading...
