27
Adjusting the tonearm's height
When installing a cartridge other than the one provided, you must maintain a suitable distance between the cartridge
and the surface of the record. Place the stylus with recommended tracking force on the record and confirm that the
tonearm is parallel to the record's surface. If it is not parallel, adjust the height of the tonearm.
1
Insert the included hexagonal wrench into the tonearm height adjustment socket and turn it
counterclockwise to unlock.
2
Adjust the tonearm height by manually lifting or lowering the tonearm assembly.
3
Reinsert the hexagonal wrench into the tonearm adjustment socket and turn it clockwise to lock the
tonearm height.
4
Place a record on the platter, position the cartridge over the record. Lower the stylus to the record
surface, and confirm that the tonearm is parallel to the record's surface.
To Next Page
Loading...
Need help?
General
