33
Specifications
Turntable specifications
Type
Belt-drive manual turntable
Motor
DC servo with Active Speed Stabilization
Drive method
Belt drive
Speeds
33-1/3 RPM, 45 RPM
Turntable platter
16 mm-thick acrylic platter
Wow and flutter
< 0.15% WRMS (33 RPM) at 3 kHz
Signal-to-noise ratio
> 60 dB
Tonearm specifications
Type
Static balanced straight carbon tonearm
Effective length
223.6 mm
Overhang
18.6 mm
Maximum tracking error angle
Less than 2.0°
Stylus pressure adjustment
range
0 to 3.0 g
Applicable cartridge weight
range (including headshell)
11.5 to 16.5g
Cartridge specifications (AT-VM95E BK)
Cartridge type
VM
Recommended load impedance
47,000 ohms
Frequency response
20 to 22,000 Hz
Output voltage
4.0 mV (mV at 1 kHz, 5 cm/sec)
Stylus
0.3 × 0.7 mil bonded elliptical stylus
Cantilever
Aluminum pipe
Tracking force range
1.8 to 2.2 g (standard 2.0 g)
Cartridge weight
6.1 g (0.22 oz)
Cartridge specifications (AT-VM95SH CL)
These specifications are for when a replacement stylus (AT-VMN95SH CL) is attached to the included cartridge.
To Next Page
Loading...
