EasyManua.ls Logo

AudioCodes 405HD - 5.8.11 Configuring Advice of Charge; 5.8.12 Configuring a Tone to Alert to Long Hold; Table 5-42: AOC Parameters; Table 5-43: Reminder Tone after Long Hold

AudioCodes 405HD
242 pages
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Loading...
400HD Series IP Phones
Administrator's Manual 108 Document #: LTRT-11973
5.8.11 Configuring Advice of Charge
Note: Support pending.
The Advice of Charge (AOC) feature can be configured. The feature permits an accurate
estimate of the size of the bill which will eventually be charged to be displayed.
To configure AOC:
Use the table as reference.
Table 5-42: AOC Parameters
Parameter Description
system/aoc/enabled
Enables the 'advice of charge' feature.
0 Disable
1 Enable
system/aoc/currency
Sets the required currency for AOC display. The string
represents the currency name (e.g., USD, EUR, NIS, etc.)
system/aoc/ratio
Sets the conversion ratio from the local currency. The string
represents the ratio between the base currency to the set
currency with a decimal point, e.g., : 3.8, 4.95, 1.
5.8.12 Configuring a Tone to Alert to Long Hold
Network administrators can configure an audible indication to be played after a call has been
on hold for a long time. After a call has been on hold for a long time (the time is configurable),
a reminder tone will be played every 10 seconds until the call is taken off hold.
To configure the feature
Use the table as reference.
Table 5-43: Reminder Tone after Long Hold
Parameter Description
voip/lhcwrr_enabled
Enables the feature.
1 Enabled. After the length of time configured for configuration file
parameter voip/lhcwrr_wait_time lapses (see the parameter below), a
reminder tone (beep) is played every 10 seconds until the call is taken
off hold.
0 Disabled (Default). No reminder tone (beep) is played, regardless of
how long the call is on hold.
voip/lhcwrr_wait_time
Defines the length of time that must lapse before a reminder tone
(beep) is played. The tone will then be played every 10 seconds until
the call is taken off hold. Default: 120 seconds.

Table of Contents

Other manuals for AudioCodes 405HD

Related product manuals