Administrator's Manual 6. Configuring Phone Settings
Version 3.4.3 135 400HD Series IP Phones
6.2.2.2 Configuring a PSK to Allow Paging during an Ongoing Call | Call Hold
Network administrators can allow users to perform paging during an ongoing call and during
call hold. To enable the feature, administrators must program a softkey for users to use the
functionality. The softkey is displayed in the ongoing call screen.
Note: Paging must be configured as described in Section 6.4 as a prerequisite for the
feature to function.
To configure a PSK for paging during call hold | ongoing call:
• Use the table as reference:
Table 6-7: Configuring a PSK for Paging during an Ongoing Call | Call Hold
Parameter Description
personal_settings/soft_keys/ongoing_call/n/ke
y_function
Set to PAGING. Note that n=0-19.
Users will view a ‘Paging’ softkey in the phone’s Hold screen (i.e., in the screen displayed
when the user holds a call):
6.2.2.3 Configuring a PSK for a Customized UI Experience
Network administrators can configure Programmable Softkeys for New Call state, Ongoing
call state and Idle screen state as part of the phone’s capability of allowing a customized
user interface experience.
Administrators can customize the ongoing call screen (shown in the figure below) in line with
the preferences / requirements of enterprise management and / or the employees.
For example, the BXfer softkey in the ongoing call screen shown in the preceding figure can
be replaced with the New Call softkey shown in the figure below on the phones of enterprise
users who infrequently transfer calls.
To Next Page
Loading...
