AudioCodes 405HD - Configuring Dial Tones; Table 5-14: Dial Tones Parameters

Administrator's Manual 5. Configuring VoIP Settings
Version 3.4.3 79 400HD Series IP Phones
5.3.3 Configuring Dial Tones
Dial Tones settings can be configured.
 To configure Dial Tones:
• Use the table as reference.
Table 5-14: Dial Tones Parameters
Parameter Description
voip/dialing/dialtone_timeout
Defines the maximum duration of the dial tone (in
seconds) after which the dial tone stops and a
reorder tone is played.
Range:1 to 300. Default: 30.
voip/dialing/warning_tone_timeout
Defines the maximum duration of the reorder
tone (in seconds) after which the reorder tone
stops and a howler tone is played.
Range:1 to 300. Default: 40.
voip/dialing/offhook_tone_timeout
Defines the duration (in seconds) of the howler
tone. If the limit is exceeded, the howler tone
stops. The howler tone indicates that the phone
has been left in an off-hook state.
Range:1 to 300. Default: 120.
voip/dialing/secondary_dial_tone/enabled
 Enables the secondary dial tone.
 0 Disable (default) - Phone doesn't use
secondary dial tone.
 1 Enable - Phone plays secondary dial tone if
the secondary dial tone key is pressed (first
digit). For example, when pressing 9 to get an
external dial tone, a different dial tone (not
configurable) is played as the second dial
tone.
voip/dialing/secondary_dial_tone/key_sequen
ce
Defines the secondary dial tone is played if this is
the first key pressed.
 Range: 0 to 9. Default: 9.
Note: This parameter is available only if the
parameter '
voip/dialing/secondary_dial_tone/enabled'
is set to 1.
voip/services/out_of_service_behavior
Determines whether a reorder tone is played
instead of a dial tone if you configured a
Registrar IP address and the registration failed.
 NONE No Tone
 REORDER_TONE Reorder Tone (default)
voip/services/msg_waiting/stutter_tone_durati
on
Defines the duration for which a stutter tone is
played when you have unheard messages.
 Range:1000 to 60000.

Default: 2500.