AudioCodes 405HD - Setting up a Remote Conference; Figure A-17: Advanced

400HD Series IP Phones
Administrator's Manual 210 Document #: LTRT-11973
Figure A-17: Advanced
9. Enter a number in the ‘Max Group Size’ field to specify the maximum number of
members allowed in the group.
10. Enter a number in the ‘Max Queue Size’ field to specify the maximum number of calls
allowed in the queue for the group.
11. From the ‘Active Subscriptions’ dropdown, select Enabled to enable SIP dialog event
package subscriptions.
12. To add members to the group, select the checkbox beside the name of each person to
be included in the GROUP MEMBERS list.
13. Click Save Group.
A.4.3 Setting up a Remote Conference
More than three participants can be added to a remote conference call. By contrast, a 'local'
conference only supports a maximum of three. The feature must be enabled on Genband’s
server. For detailed information about the feature’s capabilities, see RFC 4579, Session
Initiation Protocol (SIP) - Call Control - Conferencing for User Agents.
 To set up the remote conference feature:
• Use the table as reference.
Table 10-26: Remote Conference Parameters
Parameter Description
voip/services/application_server_type Set to GENBAND.
voip/services/conference/conf_ms_addr
Set the address of the server hosting the remote
conference: conference@SIP proxy address of
Genband’s server
voip/services/conference/mode Set the mode to REMOTE.