AudioCodes 405HD - Configuring Call Pickup; Figure A-14: Call Answer Groups

400HD Series IP Phones
Administrator's Manual 208 Document #: LTRT-11973
 To configure Genband configuration file parameters:
• Use the table as reference.
Table 10-25: Genband Configuration File Parameters
Parameter Description
voip/media/allow_multiple_rtp Configure to 1 in order to make calls with PSTN. If
it isn’t configured, only one-way voice will be
heard.
voip/services/SLA/type
Configure to to GENBAND_SCA.
voip/services/sla/barging/enable
Configure to 1. Default: 0.
voip/sla/group/0/description
[440HD only] Configure to Group1.
voip/sla/group/0/enabled
[440HD only] Configure to 1. Default: 0.
voip/sla/group/1/description
[440HD only] Configure to Group2.
voip/sla/group/1/enabled
[440HD only] Configure to 1. Default: 0.
A.4.2 Configuring Call Pickup
When configuring a call pickup group, basic configuration options determine:
 the numbers that route into a call pickup group
 whether or not vertical service code (VSC) dialing can be used by group members
 group members
Advanced configuration options allow you to specify:
 the maximum number of group members
 the maximum number of call queues
 whether or not SIP dialog event package subscriptions are enabled
 To configure a Call Pickup group:
1. Open the Genband portal in your web browser and from the ‘Provision’ menu, select
Call Answer Groups.
Figure A-14: Call Answer Groups