MP-11x & Microsoft Office Communications Server 2007
Quick Installation Guide 32 Document #: LTRT-26301
3.3.2.9 Defining Disconnect on Broken Connection
The procedure below describes how to configure the Disconnect on Broken Connection
parameter. Since Mediation Server uses Silence Suppression, it may not send Real-time
Transport Protocol (RTP) packets during the detection of silence in the call. To avoid call
disconnection by the gateway (due to RTP packets not being transmitted), you may need to
disable the parameter 'Disconnect on Broken Connection'.
¾ To define Disconnect on Broken Connection, take these 3 steps:
1. Open the ‘General Parameters’ screen (Protocol Management menu > Advanced
Parameters > General Parameters).
Figure 3-19: General Parameters Screen
2. From the ‘Disconnect on Broken Connection’ drop-down list, select ‘No’.
3. Click the Submit button to save your changes.
2
To Next Page
Loading...
