AudioCodes MediaPack MP-114 - Disabling RTCP Attribute; RTCP Attribute

MP-11x & Microsoft Office Communications Server 2007
Quick Installation Guide 36 Document #: LTRT-26301
3.3.2.13 Disabling RTCP Attribute
By default, the RTP Control Protocol (RTCP) attribute (EnableRTCPAttribute) is enabled.
However, you need to disable it by using the AdminPage of the Embedded Web Server.
¾ To disable the RTCP attribute, take these 5 steps:
1. In the Web browser's URL field, append the case-sensitive suffix ‘AdminPage’ to the IP
address (e.g., http://10.1.229.17/AdminPage).
2. On the left pane, click ini Parameters; the 'ini Parameters' screen appears in the right pane.
Figure 3-23: Admin Page – ini Parameters Screen
3. From the 'Parameter Name' drop-down list, select the parameter
'ENABLERTCPATTRIBUTE'.
4. In the 'Enter Value' field, enter 1 to disable the RTCP attribute.
5. Click Apply New Value to apply the new setting to the gateway.
3 4 5