Quick Installation Guide 6. Troubleshooting
Version 5.0 41 September 2007
¾ To configure the Syslog parameters, take these 7 steps:
1. Open the ‘Management Settings’ screen (Advanced Configuration menu > Management
Settings); the ‘Management Settings’ screen is displayed.
Figure 6-1: Management Settings Screen
2. In the 'Syslog Server IP Address' field, enter the Syslog's IP address. Note that the Syslog
server's IP address must correspond to the network environment in which the Syslog server
is installed.
3. In the 'Syslog Server Port' field, enter the UDP port number (default port is 514).
4. From the 'Enable Syslog' drop-down list, enable the Syslog feature by selecting 'Enable'.
5. In the 'Activity Types to Report' group, select the Web operations that you want logged to the
Syslog server.
6. To define the messages based on severity level that you want sent to the Syslog server,
open the ‘General Parameters’ screen (Protocol Management menu > Advanced
Parameters > General Parameters), and then from the 'Debug Level' drop-down list, select
'5' (i.e., all reports with severity level 5 are sent to the Syslog server).
7. To enable additional call information sent to the Syslog, in the 'CDR Report Level' drop-down
list, select 'End Call'
3
2
4
5
To Next Page
Loading...
Need help?
General
