39
USER'S MANUAL
bit One HD /
4
Synchronize, PC -> bit One HD or PC <- bit One HD:
these functions synchronize the PC with the bit One HD. If a dialog
box as the one to the right of this page shows up, it means that for
some reason communication between the PC and the bit One HD has
been interrupted. To restore the communication select:
• PC -> bit One HD. The PC loads the settings selected so far in the bit One HD.
• PC <- bit One HD. The PC loads the settings previously stored in the
bit One HD on the PC software.
5
Check for updates: it enables the connection to the website “www.audisonbitdrive.eu” to check if any
software / rmware updates for the bit One HD are available
(see section 9.3). To perform this operation, your
PC has to be connected to the internet.
7
Register product: this function requires an internet connection and opens the default browser to the page
for registering the product and creating a personal account in the “bit Drive” portal. This operation only
needs to be performed once; then you can access your account through the Account Login.
(see section 9.3).
6
Check for Updates on Startup: when enabled, the software automatically checks the availability of new
Firmware/PC software updates each time the program is started.
(see section 9.3).
8
Update Firmware: function to update the bit One HD rmware (see section 9.3).
9
Reset Default Answer: it restores the display of the warning messages if
they have been disabled by ticking “Don’t show me again”.
10
Restore Factory Defaults: it entirely resets the bit One HD back to
its default settings, cancelling all the data previously saved in the
bit One HD
(see section 8.2.3).
11
Restore Window Size:
this functions performs the re-sizing of the
PC software window to the default dimension. Re-sizing can also be
performed through the PC keyboard, using ALT+F10 keys.
12
Help Online:
this function requires an internet connection. By activating this
function and moving the mouse pointer to the various sections of the graphic
interface for the PC software, the concerned area will be highlighted in red.
By clicking on the red area, a link will activate, opening up the default browser,
displaying the paragraph of the manual related to that specic area. The
manual will be displayed in the language selected in CONFIG->Language.
13
Credits: it shows the information about the bit One HD software in use.
14
Exit: it exits the PC Software.
WARNING: this operation can not guarantee that the data are always retrieved.
If the operation is not successful:
1. exit the bit One HD software.
2. turn the bit One HD off.
3. turn the bit One HD on.
4. launch the bit One HD software again.
By performing these actions, synchronization will be restored but the selected settings will be lost.
WARNING: during this procedure the bit One HD RCA / AD LINK - AC LINK
outputs to the ampliers should be disconnected.
8
To Next Page
Loading...
Need help?
General
